Gateway Receiver interfacing to existing telemetry SCADA

Telemetry / Utility Gateway Receiver

The Gateway Receiver is Unique to Radio Data Networks. It was specifically as its name implies developed as a Gateway between our remote sensors and any third party Telemetry Outstation, BMS, PLC Controllers or SCADA without any risk or opening up a portal for Cyber Attack. Further it eliminates the need for software investment – the Gateway is truly a Plug and Play requiring no software, programming or configuration.

Gateway receivers are supplied with either 4 or 8 card slots, integrated radio receiver and 230V power supply with built in 12V battery backup charger. Each slot is agnostic and can accept a variety of interface cards that produce volt free contract outputs. For larger system there is a 4-way modular Gateway that can be built up to provide anything from 16 to 64 card slots.

Gateway receivers are also compatible with our remote telemetry transmitters geared for monitoring adopted pumping stations etc.

The Gateway Receiver is proven and approved for connection by many Utility companies, the Environment Agency, the NHS and a number of Industrial Companies.

8-Slot Gateway Receiver Installed at Pumping Station

8-Slot Gateway Receiver Installed at Pumping Station

Gateway Receiver Standard Features:

  • Tough Die-Cast Enclosure to Ip65
  • 230V AC or 12V dc power Supply Options (110V to order)
  • 4 or 8 Card Slot options
  • N-Type Antenna Port
  • Integrated Receiver Strip (140MHz to 950MHz) Supplied to Match System and Local Regulations
  • Pre-drilled 20mm conduit entries
  • From August 2018 available with mains failure alarm output
  • CE, R&TTE, R-ED Certified

Plug in Card Options:

  • BDTs, FDTs  Relay Cards (CSO flow monitoring) etc **
  • Digital Logic Telemetry Relay Cards **
  • Power Relay Output Card for Lighting control, etc.
  • Analogue Output 0-2V / 4-20mA Optically Isolated **
  • Serial Data Output
  • Customised cards are available to order

** Note these cards are approved by Utility, the Environment Agency, NHS for direct connection to their telemetry / SCADA

Configuring the Gateway is Childs Play!

The Gateway does not require software or programming as the identity and routeing of data is set entirely by the plug in cards. Simply if you want data from sensor with an ESN of 5207601 then you plug into the Gateway the appropriate card with the same number (we supply the cards pre-programed). Hence it is possible to receive data at one or more locations from the same sensor simply by installing two Gateways with matching cards.

Free System Configuration Service

We offer a totally free configuration service where we will supply a Gateway fully populated and tested to match your system requirements.

Sales & orders

Please call your local distributor for prices on products, systems and solutions. Spares and accessories may also be purchased through our online web portal